How To Setup STB Emu
Below is a basic setup of STB EMU and should work with
most IPTV providers.
… IPTV Service Package:
… Portal URL: this
is a link the IPTV will give you.
… MAC Address: This
can be taken from another box or most all IPTV provider
will give you one when asked for.
1… The first time it starts a box will come up click on Configure
2… The Settings page will come up go to Profiles.
If the screen comes up like this click the top right of
the screen and go to settings.
3… Go to Profile
4… Change the name to the IPTV Provider you are using.
5… Next go to Portal
6… Click on Portal
7… Each IPTV service will have a unique Portal URL that
needs to be entered. Enter that in here.
8… Next go to STB
9… Select STB
10… Select the MAG box Version to Emulate. The MAG box
compatibility will also be from your IPTV provider. If
in doubt select MAG 254 as it has wide compatibility.
11… Select Screen Resolution
12… Set the screen resolution to Auto unless
you are sure about you TVs resolution.
13… Next Select MAC
14… Enter your unique MAC address. This can be taken
from another box or the IPTV service can give you one.
15… Click on Serial Number
16… This is optional but I like to erase the serial
number so the IPTV is not tied to the box and can be
used on anther device.
17… At this point click out and EXIT
18… Reopen STB EMU which may take a few minutes to load
up the new settings.
At this point it should be ready to stream videos.
You can also order our custom loaded
TV stick or box pre-loaded with
Nile Valley NVTVOD and Nile Valley NVTVOD-3
starting at $149.99!